Performance Features:
As we are sure you’ve noticed the factory motor mounts have a ton of give in them. Our billet mounts reduce the ability of the engine to flex back by incorporating 78a durometer bushings and the billet bodies to hold them. This bushing set does a great job of limiting movement while still maintaining an acceptable level of comfort needed to be used on a daily driven street car. This both greatly enhances the fun factor and performance of the car and also removes the all too common problem of blowing out the factory mounts on your higher powered setup.

After installation you will notice the following:
Significantly reduced engine movement.
More feedback from the engine
Greatly reduced wheel hop
More defined throttle input
Smoother shifts for both DSG and Manual cars

Product Features:
Billet Aluminum Bodies
Two piece base with compression fit stainless steel center shaft
78a durometer bushings
Grade 10.9 zinc plated hardware
Black anodized finish

Compatibility with various OEM configurations:

Audi A3 2.0T FSI/TSI

VW GTI & GLI 2.0T FSI/TSI

VW Passat 2.0T FSI/TSI (Manual Trans Only)

Important Note:
You will greatly reduce the life expectancy of the remaining stock side mount by only running either the engine or transmission mount. We strongly recommend using them as a pair. We take no responsibility for added wear or failure to stock components.